How do I move past this stage?

The monitor reads Attention wait 5 mins for start up

installed magnum intelligent control thermostat to replace a pre-existing (faulty) thermostat. However the displayed temperature is a negative number. Any idea why please?

Hi, will the timer be effective on automatic mode or does it need to be in a different mode? Thank you

I can not seem to locate the app on AppStore or GooglePlay, can you provide a link or any further info.?

Can you use the Klima 825502 without the Floor sensor and run it on room temp

I find the existing intelligent controller a bit difficult to use - is this a replacement, can it be fitted easily, and is there any change in functionality?

Hi, I have 2x C16 installed from two separate fused spurs in my house.
When the fused spur is switched on and the thermostat switch is off, then each thermostat is drawing off quite a bit of power (nearly as much as when both switched on) Any ideas why this is the case, or if there could be a problem?
Many thanks.

First turn on after installation, back light on but nothing on the screen, waited as per instruction manual for 5 mins after turning on for instructions to appear on screen. Now 15 mins and screen still blank just back light on, no flashing led either

Hi - my thermostat was installed for underfloor heating about 18 months ago and has been working fine. However there the thermostat seems to have died and will no longer switch on. Is it likely to be an issue with the thermostat itself or something else. There are no other power issues around it.